For burr-free and precise pipe coils out of the bend

With our specially developed solution it is also possible to reliably process very thin-walled pipes.
With our specially developed solution it is also possible to reliably process very thin-walled pipes.

Be it a boiler or heat exchanger – pipe coils are in use in numerous systems. However, because it is only possible to fit them with precisely installed outlets we have developed a special solution for our customers, which implements precisely positioned bending of the pipe ends and cuts without cross-sectional losses.

For this purpose a robot first places the coiled pipes in a measuring device. This ascertains the diameter and length of the pipe coils and therefore determines the precise position of the outlets. On the basis of this measuring data the part is then positioned in a right/left-bending machine and the pipe ends are precisely bent in turn – with less than 5 percent ovality.

After this, a fully automatic processing system carries out the burr-free cutting and axial conification. In this way it is also possible to process thin-walled pipes with the utmost precision. The possibility of sealing both frontally and on the threads provides additionally flexibility. For this purpose our advanced process applies a frontal sealing surface for flat-sealing elements to the pipe ends, and rolls a conical thread in combination with this. This facilitates the economical and clean generation of a tight pipe coil.

Go back

transfluid®
Maschinenbau GmbH

Hünegräben 20-22
57392 Schmallenberg
Germany

sales@transfluid.de

+49 29 72 / 97 15 0

+49 29 72 / 97 15 11